$15 Eheim Jager Aquarium Thermostat Heater Pet Supplies Fish Aquatic Pets Aquarium Heaters Chillers Eheim Jager Aquarium Industry No. 1 Heater Thermostat Jager,diegomp.com,Thermostat,Eheim,Pet Supplies , Fish Aquatic Pets , Aquarium Heaters Chillers,Aquarium,Heater,$15,/glandulous478163.html Jager,diegomp.com,Thermostat,Eheim,Pet Supplies , Fish Aquatic Pets , Aquarium Heaters Chillers,Aquarium,Heater,$15,/glandulous478163.html Eheim Jager Aquarium Industry No. 1 Heater Thermostat $15 Eheim Jager Aquarium Thermostat Heater Pet Supplies Fish Aquatic Pets Aquarium Heaters Chillers
All 9 EHEIM Heater models are 100% fully submersible and come with a new TruTemp dial that allows the user to recalibrate the heater within a +/- 0.5F degree accurancy for precise temperature readings.
Directions for installing and using your Aqueon ProHeater
Caution: Before working with or installing heater, be sure to read and understand all safety instructions and warnings.
Attach suction cups: Remove sticker around power monitor light. Attach suction cups to heater. Attaching both suction cups will ensure proper positioning in your aquarium and will allow adequate water circulation around the heater for even heat distribution. Suction cups should be placed in the middle to upper portion of the heater.
Set heater temperature: Turn the adjustment knob until it corresponds to the desired aquarium temperature. As all aquariums vary, further adjustment may be required to maintain desired temperature.
Heater installation: Install heater in water filled aquarium. The heater works best when installed in the aquarium in the vertical position. The installation of the heater in this position requires that the aquarium must maintain a water level above the minimum water level on the heater. The heater can be installed in the aquarium in the horizontal position. The installation of the heater in this position requires that the heater be positioned fully submerged in water at all times.
Plug into electrical outlet: Allow for heater to be submerged in water for a minimum of 30 minutes prior to powering the appliance. Once heater has been mounted and submerged for the 30 minutes, plug the appliance into an electrical outlet. Once plugged in, the heater will automatically start working and the power monitor light will illuminate. A red light indicates the unit is heating and a green light indicates the unit has reached the set temperature.
Adjust temperature: Allow the heater to run for 24 hours at the original setting prior to adjusting. Check the aquarium water with a reliable thermometer. Should the heater need to be adjusted from the original setting, slightly turn the adjustment knob + or - the number of degrees, as needed. Once adjusted, wait 24 hours and repeat if necessary. Note: Do not over adjust the heater, this may cause harm to your aquarium inhabitants and environment. Make sure of the required temperature for your specific setup.
19" rod for aquariums 159 - 264 gallons
The reason Jager heaters have a reputation for being the most accurate heaters available is the ability to recalibrate the heater.
The factory setting should be reasonably close but if you moved either the red arrow or the blue dial before reading the instructions you may need to recalibrate the heater.
Precisely regulated, constant water temperature is very important for the comfort and success of your aquarium inhabitants. The JÃÂ¤ger TruTemp adjustable heater is an ultra-modern electronic thermal device offering today's best technology. Designed for use in both freshwater and saltwater aquarium, JÃÂ¤ger TruTemp fully-submersible heaters include these great features:
Shatterproof glass construction - Made with laboratory-grade glass, TruTemp heaters are free of pollutants, resistant to chemical and biological substances, and able to withstand extreme temperature fluctuations. Their glass jackets also enlarge the heating surface and ensure even heat distribution.
TruTemp Dial - Temperature can be precisely adjusted from 18ÃÂ° to 34ÃÂ° C (65ÃÂ° to 93ÃÂ° F). Using the TruTemp dial with readjustment ring, the user can recalibrate the heater for a precise temperature reading. Control accuracy is +/- 0.5ÃÂ° C.
Thermo Safety Control - This safety mechanism enables 'running-dry' protection. The heater will shut off when removed from the water, and resume functioning upon return.
On/Off Indicator Light - This convenient feature eliminates guessing and enables the user to verify heater function without getting their hands wet!
Each JÃÂ¤ger TruTemp Heater also includes a mounting bracket and suction cups for secure and flexible placement within your aquarium system. Lastly, an extra long power cord accommodates most applications.
I never dreamed about success. I worked for it. - Estee Lauder